襄阳境外驾照换领中国驾照

1. When a vehicle on the main road approaches a conjunction with a feeder road, the driver should ______ in order to prevent a collision with a vehicle that suddenly enters from the feeder road.

A. Maintain the normal speed

B. Reduce speed in advance, observe and drive with care

C. Honk and swiftly pass

D. Speed up in advance and pass

Answer: B

2. What is the max speed when down slope, turning around and U turn?

A. 50km/hr

B. 60km/hr

C. 30km/hr

D. 40km/hr

Answer: C

3. Using the high and low beam lights alternately while driving on the road of this kind of sharp curve.

Answer: Y

4. When a vehicle goes downhill, it may fully use the neutral gear and slide.

Answer: N

5. After entering the acceleration lane of an expressway, the driver should increase the speed to more than _________ per hour.

A. 50

B. 60

C. 30

D. 40

Answer: B

6. According to rules on the road traffic safety, the maximum speed on the expressway is less than 120km/hr, thus, it will not be in violation of the traffic regulations as long as the speed does not exceed 120km/hr on the expressway.

Answer: N

7. The main feature of pedestrians participating in road traffic is that _________.

A. They move slowly

B. They like to get together and look on

C. They walk around at will and can easily change directions

D. All the above

Answer: C

8. When a vehicle overtakes the bike riders going in the same direction, the rational way to deal with is to ________.

A. Continuously honk to remind them to yield

B. Continuously honk and speed up to overtake

C. Yield to the bike riders

D. Observe them, reduce speed and go slowly, while keeping a sufficient safe distance.

Answer: D

9. When a vehicle reaches a muddy or burst-and-muddy section, the driver should stop,observe and select the level and solid section or the section with vehicle tracks.

Answer: Y

10. When a vehicle passes a bumped road, the driver should ________.

A. Speed up and dash over under inertia

B. Change to the neutral gear and slide over

C. Maintain the original speed and pass

D. Pass slowly and steadily

Answer: D

11. When driving at night on a road with no or poor lighting, the driver should switch from the low beam light to the high beam light. But the vehicle following in the same direction is not allowed to use the high beam light.

Answer: Y

12. When encountering a traffic jam on the expressway, the driver should follow the front vehicle lining up, and immediately turn on the hazard light to prevent rear-end collision.

Answer: Y

13. The main impact of muddy roads on safe driving is _________.

A. The resistance to the vehicle becomes weaker

B. The tires can easily spin and skid

C. The visibility become lower and blurs the field of vision

D. The road grip becomes stronger

Answer: B

14. When driving at night on a road that has good lighting, the driver should use _______.

A. The fog light

B. The low beam light

C. The high beam light

D. The hazard lights

Answer: B

15. When a vehicle approaches an intersection without crosswalk, the driver should _______ if he finds people are crossing the street.

A. Reduce speed or stop to yield

B. Honk to indicate them to yield

C. Immediately change lane and bypass the pedestrians

D. Pass before the pedestrians

Answer: A

16. After a vehicle enters the ramp, the driver should swiftly increase the speed to more than 60 kilometers per hour.

Answer: N

17. Registration alternation is not needed when _____

A. change engine

B. add anti-collision device

C. change vehicles colour

D. change the chassis

Answer: B

18. You have the priviledged passing right of way at the intersection in this situation.

Answer: N

19. Emergency braking on a road covered by ice and snow can easily cause side skidding. The driver should use the engine braking to reduce speed.

Answer: Y

20. When the vehicles cross each other at night, the driver may continuous change lights to remind the vehicle coming in the opposite direction and at the same should reduce speed and go forward or stop on the right side.

Answer: Y