安阳考摩托车科目四英文题和答案

1. When an erosive material catches fire, it should not be put out with water cannon.

Answer: Y

2. Once inflammable gas causes a fire disaster, it should be put out with water in good time.

Answer: N

3. When driving on a long downhill road, which is the best way to control driving speed?

A. Coast in neutral gear

B. Depress the clutch and coast

C. Use the engine to brake

D. Depress the brake pedal continuously

Answer: C

4. When approaching another vehicle at night, why should the driver alternate between high-and-low-beam at a distance more than 150 meters?

A. Warn each other before passing

B. Driving habit

C. Easy to observe the situation ahead from either side

D. Courtesy

Answer: C

5. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

6. What is the meaning of this sign?

A. Driving at reduced speed in the section of 40 meters

B. Minimum speed is 40km/hr

C. Maximum speed is 40km/hr

D. 40km/hr speed limit ban is lifted

Answer: D

7. Which one of the following measures is correct when a motor vehicle intends to overtake but the vehicle infront refuses to yield?

A. Use a long-sounding horn

B. Follow the vehicle in front while turning high-beam

C. Wait for it to yield while keeping a safe distance

D. Use high-beam and low-beam alternatively

Answer: C

8. What is the meaning of this sign?

A. U turn

B. Reversing

C. Left turn

D. Bypassing

Answer: A

9. What is the meaning of this sign?

A. No borrowing lane

B. No changing lane

C. No overtaking

D. No U turn

Answer: C

10. The article that cannot be used to stop bleeding by dressing is _________.

A. Bondage

B. Sling

C. Tourniquet

D. Hemp rope

Answer: D

11. When following other vehicles on the uphill section of a mountain road, what should the driver do if the vehicle in front stops?

A. Overtake from either side of the front vehicle

B. Stop close to the vehicle in front

C. Stop with a larger space from the vehicle in front

D. Sound the horn continuously to warn the other driver

Answer: C

12. When the tire pressure is too low, what will happen if the tire changes its shape in waves and increases in temperature due to fast movement?

A. Unstable tire pressure

B. Even lower tire pressure

C. Driving resistance increases

D. Tire burst

Answer: D

13. What is the meaning of this sign?

A. Road narrows on both sides

B. Road narrows on the right side

C. Road narrows on the left side

D. Bridge narrows

Answer: A

14. When a motor vehicle passes over an overflowing bridge, what should the driver do after stopping and observing closely?

A. Change to a high gear and pass rapidly

B. Constantly observe the changes of the flow

C. Prepare to stop at any time

D. Change to a low gear and pass through at a constant speed

Answer: D

15. What is the meaning of this sign?

A. Continuous down slopes

B. Steep downhill road

C. Steep uphill road

D. Continuous up slopes

Answer: A

16. When encountering a vehicle in front ascending on a mountainous road covered with ice and snow, what should the motor vehicle driver do?

A. Ascend after the vehicle in front passes the slope

B. Overtake the vehicle in front swiftly and drive on

C. Overtake the vehicle in front with a slow speed and drive on

D. Follow the vehicle in front closely

Answer: A

17. What is the meaning of this sign?

A. Reducing speed 40m ahead

B. Minimum speed is 40km/hr

C. Axle weight limit is 40 tons

D. Maximum speed limit is 40km/hr

Answer: D

18. What is the meaning of this sign?

A. Turn left

B. No going straight

C. Straight-going lane

D. One-way road

Answer: A

19. What is the meaning of this sign?

A. Hump bridge

B. High outburst road

C. Low-lying road

D. Bump road

Answer: A

20. How to ensure motor vehicles have sufficient power when driving uphill?

A. Downshift before reducing speed

B. Downshift after reducing speed

C. Downshift when the speed is excessively low

D. Downshift to the fullest extent

Answer: A