无锡考摩托车科目四英语版

1. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

2. What is the meaning of this sign?

A. Continuous down slopes

B. Steep downhill road

C. Steep uphill road

D. Continuous up slopes

Answer: A

3. How to ensure motor vehicles have sufficient power when driving uphill?

A. Downshift before reducing speed

B. Downshift after reducing speed

C. Downshift when the speed is excessively low

D. Downshift to the fullest extent

Answer: A

4. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C

5. What is the meaning of this sign?

A. No borrowing lane

B. No changing lane

C. No overtaking

D. No U turn

Answer: C

6. What is the meaning of this sign?

A. Y-shaped intersection

B. T-shaped intersection

C. Intersection

D. Ring intersection

Answer: B

7. What is the meaning of this sign?

A. More vehicles section

B. Passing slowly

C. Jammed section

D. Construction section

Answer: B

8. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

9. Which of the following is an inflammable solid material?

A. Matches

B. Fireworks

C. Calcium carbide

D. Explosives

Answer: A

10. What is the meaning of this sign?

A. Bypass from left side

B. Continuous curves

C. Sharp left curve

D. Sharp right curve

Answer: C

11. Which lamp should be turned on when motor vehicles pass through a road section at night where the street light condition is good?

A. Front and rear fog lamps

B. Low-beam

C. High-beam

D. Hazard lamp

Answer: B

12. What needs attention when a motor vehicle drives on a road covered with ice and snow?

A. Braking length is extended

B. Anti-skating resistance will be greater

C. The adhesive force of the road will be greater

D. The braking length will be shorter

Answer: A

13. When a wounded person is under the wheel or cargo, the wrong method is to pull the limbs of the wounded.

Answer: N

14. What is the meaning of this sign?

A. Hump bridge

B. High outburst road

C. Low-lying road

D. Bump road

Answer: A

15. When a motor vehicle temporarily stops in fog, which lamp should be turned on?

A. Hazard lamp, clearance lamp and rear position lamp

B. Left-turn indicator, clearance lamp and rear position amp

C. Headlamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: A

16. When approaching a vehicle on a narrow slope, which one of the following ways is correct?

A. The descending vehicle yields to the ascending

B. The vehicle which is further from the slope crest should yield

C. The ascending vehicle yields to the descending

D. If the descending vehicle has reached the midpoint while the ascending vehicle has not yet set out, the descending vehicle must yield.

Answer: A

17. When rescuing a person sustaining full-body burns the rescue personnel may spray cool water to his body to put out the fire.

Answer: N

18. The wrong method to rescue a poisoned person in a traffic accident is to ______.

A. Bring him to a place where air is fresh

B. Take off clothes that are exposed to toxic air

C. Clean exposed areas with clean water

D. Stay in the original place and wait for the rescue personnel

Answer: D

19. How to ensure safe driving at night?

A. Drive at speed limit

B. Cut speed and drive carefully

C. Maintain the current speed

D. Drive above the speed limit

Answer: B

20. When there is bleeding at the bone fracture of a wounded person, the first thing to do is to keep it in position before stopping the bleeding and dress the wound.

Answer: N