临夏摩托车科目四仿真考试

1. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

2. Which lamp should be turned on when motor vehicles pass through a road section at night where the street light condition is good?

A. Front and rear fog lamps

B. Low-beam

C. High-beam

D. Hazard lamp

Answer: B

3. When a wounded person suffering burns is thirsty, he may drink a small quantity of slightly salty water.

Answer: Y

4. When approaching a vehicle on a narrow slope, which one of the following ways is correct?

A. The descending vehicle yields to the ascending

B. The vehicle which is further from the slope crest should yield

C. The ascending vehicle yields to the descending

D. If the descending vehicle has reached the midpoint while the ascending vehicle has not yet set out, the descending vehicle must yield.

Answer: A

5. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

6. What is the meaning of this sign?

A. Bump road

B. Low-lying road

C. High outburst road

D. Hump bridge

Answer: B

7. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

8. Which one of the following measures is correct when a motor vehicle intends to overtake but the vehicle infront refuses to yield?

A. Use a long-sounding horn

B. Follow the vehicle in front while turning high-beam

C. Wait for it to yield while keeping a safe distance

D. Use high-beam and low-beam alternatively

Answer: C

9. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C

10. What is the meaning of this sign?

A. Straight-going lane

B. Going straight only

C. One-way road

D. No going straight

Answer: B

11. When there is bleeding at the bone fracture of a wounded person, the first thing to do is to fix the wounded part in position, then stop the bleeding and dress the wound.

Answer: N

12. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

13. When rescuing a wounded person in coma, it is necessary to take warm-keeping measures to prevent heat loss.

Answer: Y

14. When the wounded person is suffering main artery bleeding, where should the rescue personnel press by thumb to stop the bleeding?

A. The artery near the heart

B. The artery lower to the wound

C. The artery further from the heart

D. The artery in the center of the wound

Answer: A

15. When a gas tanker is leaking heavily, which of the following measures is wrong?

A. Cut off the power

B. Wear gas mask and protect gloves

C. Turn off the valve to stop leaking

D. Evacuate people to the leeward side

Answer: D

16. Rescue personnel should check the breath of the unconscious person before applying any other emergency treatment.

Answer: Y

17. What is the meaning of this sign?

A. Bypass from left side

B. Continuous curves

C. Sharp left curve

D. Sharp right curve

Answer: C

18. What is the meaning of this sign?

A. Passing by the right side

B. Passing by the left side

C. Running to right side

D. Running the roundabout

Answer: D

19. What is the meaning of this sign?

A. Crosswalk lights

B. Watch for pedestrians

C. Attention to traffic lights

D. Intersection

Answer: C

20. When a wounded person suffering burns is thirsty, he should only drink plain boiled water.

Answer: N