云南摩托车科目四英文考试题库

1. What is the most frequent problem for driving on a muddy road?

A. High resistance force

B. Sideways slide

C. The motor vehicle bumps

D. Steering failure

Answer: B

2. What is the meaning of this sign?

A. The lane for non-motorized vehicles

B. Yield non-motorized vehicles

C. No passing for non-motorized vehicles

D. Watch for non-motorized vehicles

Answer: D

3. What is the meaning of this sign?

A. Downhill section on right side

B. Driving by the right side of the road

C. Stopping by the right side of the road

D. Right turn only

Answer: B

4. When a motor vehicle encounters an accident, the driver should pay attention to whether there is fuel leakage, pipeline rupture, so as avoid accidents.

Answer: Y

5. What is the meaning of this sign?

A. Stopping temporarily is allowed

B. Long stopping is allowed

C. No long stopping

D. No stopping

Answer: D

6. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: D

7. What is the meaning of this sign?

A. Reducing speed 40m ahead

B. Minimum speed is 40km/hr

C. Axle weight limit is 40 tons

D. Maximum speed limit is 40km/hr

Answer: D

8. What is the meaning of this sign?

A. Bump road

B. Low-lying road

C. High outburst road

D. Hump bridge

Answer: B

9. Which lamp should be turned on when motor vehicles pass through a road section at night where the street light condition is good?

A. Front and rear fog lamps

B. Low-beam

C. High-beam

D. Hazard lamp

Answer: B

10. What is the meaning of this sign?

A. Watch for pedestrians

B. Crosswalk

C. Village or town

D. Primary school

Answer: C

11. When driving on a long downhill road, which is the best way to control the speed?

A. Coast in neutral gear

B. Take a low gear

C. Depress the clutch

D. Pull up the handbrake

Answer: B

12. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

13. Which of the following measures is incorrect when a motor vehicle stops?

A. Stop at a stipulated place

B. Avoid stopping on pedestrian streets

C. Avoid obstructing the passing of other motor vehicles and pedestrians when temporarily stops on the road

D. Stop on the non-motor vehicle lane

Answer: D

14. When a motor vehicle stops in snow, which lamp should be turned on?

A. Front and rear fog lamps, clearance lamp and rear position lamp

B. Reverse lamp, clearance lamp and rear position lamp

C. Headlamp, clearance lamp and rear position lamp

D. Hazard lamps, clearance lamp and rear position lamp

Answer: D

15. What is the meaning of this sign?

A. Electric bicycles may go

B. Parking space for non-motorized vehicles

C. Parking area for non-motorized vehicles

D. Non-motorized vehicles may go

Answer: D

16. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

17. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

18. When rescuing the injured, it is necessary to ________.

A. Save life first and treat the wounds later

B. Treat the wounds first and safe life later

C. Help the slightly wounded persons first

D. Help the seriously wounded persons later

Answer: A

19. What is the meaning of this sign?

A. No U turn at intersection

B. No changing lane from both sides

C. No left or right turn

D. No going straight

Answer: C

20. What influence does smoking have upon driving?

A. Harmful for safe driving

B. Increase concentration

C. Help relaxation

D. No effect on driving

Answer: A