漳州摩托车科目四英文版app

1. Which of the following measures is incorrect when a motor vehicle stops?

A. Stop at a stipulated place

B. Avoid stopping on pedestrian streets

C. Avoid obstructing the passing of other motor vehicles and pedestrians when temporarily stops on the road

D. Stop on the non-motor vehicle lane

Answer: D

2. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

3. When rescuing a wounded person who has been poisoned by toxic gas, the first measure is to send him/her to a place with fresh air so that he/she will not continue to be poisoned.

Answer: Y

4. When there is bleeding at the bone fracture of a wounded person, the first thing to do is to keep it in position before stopping the bleeding and dress the wound.

Answer: N

5. Which of the following is an inflammable solid material?

A. Matches

B. Fireworks

C. Calcium carbide

D. Explosives

Answer: A

6. When a wounded person suffering burns is thirsty, he may drink a small quantity of slightly salty water.

Answer: Y

7. Which lamp should be turned on when motor vehicles pass through a road section at night where the street light condition is good?

A. Front and rear fog lamps

B. Low-beam

C. High-beam

D. Hazard lamp

Answer: B

8. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

9. Rescue personnel should check the breath of the unconscious person before applying any other emergency treatment.

Answer: Y

10. What is the meaning of this sign?

A. Stopping temporarily is allowed

B. Long stopping is allowed

C. No long stopping

D. No stopping

Answer: D

11. What should be checked before driving?

A. No parts need to be checked

B. Whether the tires have been cleaned

C. Where the spare tire is placed

D. The fastening and air pressure of tires

Answer: D

12. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: D

13. How should lamps be used by the motor vehicle driver who follows a vehicle on a road section at night where he street light condition is good?

A. Turn off the headlamp

B. Use high-beam

C. Turn off all lamps

D. Use low-beam

Answer: D

14. What is the meaning of this sign?

A. Reducing speed 40m ahead

B. Minimum speed is 40km/hr

C. Axle weight limit is 40 tons

D. Maximum speed limit is 40km/hr

Answer: D

15. What is the meaning of this sign?

A. Intersection

B. Ring intersection

C. T-shaped intersection

D. Y-shaped intersection

Answer: A

16. When approaching a vehicle on a narrow slope, which one of the following ways is correct?

A. The descending vehicle yields to the ascending

B. The vehicle which is further from the slope crest should yield

C. The ascending vehicle yields to the descending

D. If the descending vehicle has reached the midpoint while the ascending vehicle has not yet set out, the descending vehicle must yield.

Answer: A

17. What is the meaning of this sign?

A. No U turn

B. No changing to left lane

C. No turning left

D. No entering the left lane

Answer: C

18. What is the meaning of this sign?

A. Y-shaped intersection

B. T-shaped intersection

C. Intersection

D. Ring intersection

Answer: B

19. When a gas tanker is leaking heavily, which of the following measures is wrong?

A. Cut off the power

B. Wear gas mask and protect gloves

C. Turn off the valve to stop leaking

D. Evacuate people to the leeward side

Answer: D

20. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C