怒江外国人考中国摩托车驾照科目四试题

1. When approaching a vehicle on a narrow slope, which one of the following ways is correct?

A. The descending vehicle yields to the ascending

B. The vehicle which is further from the slope crest should yield

C. The ascending vehicle yields to the descending

D. If the descending vehicle has reached the midpoint while the ascending vehicle has not yet set out, the descending vehicle must yield.

Answer: A

2. When driving on a long downhill road, which is the best way to control the speed?

A. Coast in neutral gear

B. Take a low gear

C. Depress the clutch

D. Pull up the handbrake

Answer: B

3. When following other vehicles on the uphill section of a mountain road, what should the driver do if the vehicle in front stops?

A. Overtake from either side of the front vehicle

B. Stop close to the vehicle in front

C. Stop with a larger space from the vehicle in front

D. Sound the horn continuously to warn the other driver

Answer: C

4. What is the meaning of this sign?

A. No borrowing lane

B. No changing lane

C. No overtaking

D. No U turn

Answer: C

5. What is the meaning of this sign?

A. No honking the tweeter

B. No honking the woofer

C. Should honk

D. No honking

Answer: C

6. When removing a wounded person suffering spinal fracture, the rescuer should never help the wounded person to walk. He may be carried away with a soft stretcher.

Answer: N

7. When driving on road sections where safe sight distance is affected, such as the top of a ramp, what should drivers do to ensure safety?

A. Rush through

B. Use hazard lamp

C. Cut speed and sound the horn

D. Drive at will

Answer: C

8. Dangerous chemicals possess the characteristics of explosion, inflammation, poison, erosion and radiation.

Answer: Y

9. When rescuing a wounded person suffering spinal fracture, it is necessary to ___________.

A. Take warm-keeping measure

B. Use soft stretcher to carry

C. Use sling to keep in position

D. Help the wounded person to move

Answer: C

10. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

11. When approaching another vehicle at night, why should the driver alternate between high-and-low-beam at a distance more than 150 meters?

A. Warn each other before passing

B. Driving habit

C. Easy to observe the situation ahead from either side

D. Courtesy

Answer: C

12. How should lamps be used by the motor vehicle driver who follows a vehicle on a road section at night where he street light condition is good?

A. Turn off the headlamp

B. Use high-beam

C. Turn off all lamps

D. Use low-beam

Answer: D

13. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

14. Once inflammable gas causes a fire disaster, it should be put out with water in good time.

Answer: N

15. What is the meaning of this sign?

A. Bump road

B. Low-lying road

C. High outburst road

D. Hump bridge

Answer: B

16. What is the meaning of this sign?

A. No yielding

B. Yield while crossing each other

C. Reduce speed and yield

D. Stop to yield

Answer: C

17. When a motor vehicle stops in snow, which lamp should be turned on?

A. Front and rear fog lamps, clearance lamp and rear position lamp

B. Reverse lamp, clearance lamp and rear position lamp

C. Headlamp, clearance lamp and rear position lamp

D. Hazard lamps, clearance lamp and rear position lamp

Answer: D

18. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: C

19. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: D

20. When rescuing a person sustaining full-body burns the rescue personnel may spray cool water to his body to put out the fire.

Answer: N