平顶山摩托车科目四仿真考试

1. What is the meaning of this sign?

A. Continuous down slopes

B. Steep downhill road

C. Steep uphill road

D. Continuous up slopes

Answer: A

2. What is the most frequent problem for driving on a muddy road?

A. High resistance force

B. Sideways slide

C. The motor vehicle bumps

D. Steering failure

Answer: B

3. What needs attention when a motor vehicle drives on a road covered with ice and snow?

A. Braking length is extended

B. Anti-skating resistance will be greater

C. The adhesive force of the road will be greater

D. The braking length will be shorter

Answer: A

4. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

5. When rescuing the persons who are losing blood, it is necessary to ______ first.

A. Observe

B. Dress the wounds

C. Stop bleeding

D. Inquire

Answer: C

6. What is the meaning of this sign?

A. Accident-prone section

B. Construction section

C. Reducing speed and going slowly section

D. Jammed section

Answer: A

7. What is the meaning of this sign?

A. Passing by the right side

B. Passing by the left side

C. Running to right side

D. Running the roundabout

Answer: D

8. What is the meaning of this sign?

A. No going straight and no changing to left lane

B. No going straight and no left turn

C. Allowed to go straight and turn left

D. No going straight and no right turn

Answer: B

9. The article that cannot be used to stop bleeding by dressing is _________.

A. Bondage

B. Sling

C. Tourniquet

D. Hemp rope

Answer: D

10. What is the meaning of this sign?

A. No passing

B. Driving at reduced speed

C. Time limit for entering

D. No entering

Answer: A

11. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

12. When a motor vehicle encounters a burning phenomenon, it should leave the vehicle quickly so as not to cause injury or asphyxia to the respiratory tract.

Answer: Y

13. When driving on a long downhill road, which is the best way to control driving speed?

A. Coast in neutral gear

B. Depress the clutch and coast

C. Use the engine to brake

D. Depress the brake pedal continuously

Answer: C

14. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

15. What is the meaning of this sign?

A. No stopping temporarily

B. No long stopping

C. No stopping

D. Long stopping is allowed

Answer: B

16. What is the meaning of this sign?

A. No U turn

B. No changing to left lane

C. No turning left

D. No entering the left lane

Answer: C

17. What is the meaning of this sign?

A. Reduce speed and go slowly

B. Watch for danger

C. Jammed section

D. Accident-prone section

Answer: B

18. When a motor vehicle passes over an overflowing bridge, what should the driver do after stopping and observing closely?

A. Change to a high gear and pass rapidly

B. Constantly observe the changes of the flow

C. Prepare to stop at any time

D. Change to a low gear and pass through at a constant speed

Answer: D

19. When approaching another vehicle at night, why should the driver alternate between high-and-low-beam at a distance more than 150 meters?

A. Warn each other before passing

B. Driving habit

C. Easy to observe the situation ahead from either side

D. Courtesy

Answer: C

20. When rescuing a wounded person who has been poisoned by toxic gas, the first measure is to send him/her to a place with fresh air so that he/she will not continue to be poisoned.

Answer: Y