哈尔滨考摩托车科目四英文版电子题库

1. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

2. When driving on a long downhill road, which is the best way to control the speed?

A. Coast in neutral gear

B. Take a low gear

C. Depress the clutch

D. Pull up the handbrake

Answer: B

3. What is the meaning of this sign?

A. Crosswalk

B. Students¡¯ passage

C. Watch for pedestrians

D. Children¡¯s passage

Answer: A

4. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

5. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C

6. What is the meaning of this sign?

A. No going straight and no changing to left lane

B. No going straight and no left turn

C. Allowed to go straight and turn left

D. No going straight and no right turn

Answer: B

7. What is the meaning of this sign?

A. Accident-prone section

B. Construction section

C. Reducing speed and going slowly section

D. Jammed section

Answer: A

8. What is the meaning of this sign?

A. No yielding

B. Yield while crossing each other

C. Reduce speed and yield

D. Stop to yield

Answer: C

9. When the wounded person is suffering main artery bleeding, where should the rescue personnel press by thumb to stop the bleeding?

A. The artery near the heart

B. The artery lower to the wound

C. The artery further from the heart

D. The artery in the center of the wound

Answer: A

10. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

11. Which lamp should be turned on when motor vehicles pass through a road section at night where the street light condition is good?

A. Front and rear fog lamps

B. Low-beam

C. High-beam

D. Hazard lamp

Answer: B

12. What is the meaning of this sign?

A. Reducing speed 40m ahead

B. Minimum speed is 40km/hr

C. Axle weight limit is 40 tons

D. Maximum speed limit is 40km/hr

Answer: D

13. What is the meaning of this sign?

A. Watch for pedestrians

B. Crosswalk

C. Village or town

D. Primary school

Answer: C

14. What is the meaning of this sign?

A. The lane for non-motorized vehicles

B. Yield non-motorized vehicles

C. No passing for non-motorized vehicles

D. Watch for non-motorized vehicles

Answer: D

15. What is the meaning of this sign?

A. No left turn

B. Leftt and right turn

C. No leftt and right turn

D. No right turn

Answer: B

16. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

17. What should the driver do to follow other motor vehicles on a mountain road?

A. Closely follow the vehicle in front

B. Increase the safety distance

C. Reduce the vertical distance between vehicles

D. Try to overtake the vehicle in front as soon as possible

Answer: B

18. When putting out a fire disaster that gives out erosive steam or poisonous gas, the firefighters should wear gas masks and other related protective articles and should operate from the windward side.

Answer: Y

19. What is the meaning of this sign?

A. Road narrows on both sides

B. Road narrows on the right side

C. Road narrows on the left side

D. Bridge narrows

Answer: A

20. What is the meaning of this sign?

A. Stop by the left side of the road

B. Downhill section left

C. Left turn only

D. Run by the left side of the road

Answer: D