黄山摩托车科目四英文版试题

1. The article that cannot be used to stop bleeding by dressing is _________.

A. Bondage

B. Sling

C. Tourniquet

D. Hemp rope

Answer: D

2. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

3. When driving on a long downhill road, which is the best way to control the speed?

A. Coast in neutral gear

B. Take a low gear

C. Depress the clutch

D. Pull up the handbrake

Answer: B

4. When approaching another vehicle at night, why should the driver alternate between high-and-low-beam at a distance more than 150 meters?

A. Warn each other before passing

B. Driving habit

C. Easy to observe the situation ahead from either side

D. Courtesy

Answer: C

5. What is the meaning of this sign?

A. No left turn

B. Leftt and right turn

C. No leftt and right turn

D. No right turn

Answer: B

6. What is the meaning of this sign?

A. More vehicles section

B. Passing slowly

C. Jammed section

D. Construction section

Answer: B

7. When an erosive material catches fire, it should not be put out with water cannon.

Answer: Y

8. When driving in thick or extremely thick fog, what should the driver do due to the low visibility in such weather?

A. Turn on the headlamp and drive slowly

B. Turn on the fog lamp and drive slowl

C. Park in a safe place

D. Drive slowly close to the roadside

Answer: C

9. When putting out a fire disaster that gives out erosive steam or poisonous gas, the firefighters should wear gas masks and other related protective articles and should operate from the windward side.

Answer: Y

10. What is the meaning of this sign?

A. Exit and entry for disabled people

B. Watch for disabled people

C. Rest area for disabled people

D. Special passage for disabled people

Answer: B

11. What should the driver do when he/she encounters an oncoming ambulance in the same lane?

A. Keep to the side and reduce speed or stop to yield

B. Drive ahead by occupying another lane

C. Yield by speeding up and changing lanes

D. Drive ahead in the original lane

Answer: A

12. What is the meaning of this sign?

A. Straight-going lane

B. Going straight only

C. One-way road

D. No going straight

Answer: B

13. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

14. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

15. The wrong method to rescue a poisoned person in a traffic accident is to ______.

A. Bring him to a place where air is fresh

B. Take off clothes that are exposed to toxic air

C. Clean exposed areas with clean water

D. Stay in the original place and wait for the rescue personnel

Answer: D

16. What is the meaning of this sign?

A. Bypass from left side

B. Continuous curves

C. Sharp left curve

D. Sharp right curve

Answer: C

17. What is the meaning of this sign?

A. Sharp right curve

B. Bypass from right side

C. Continuous curves

D. Sharp left curve

Answer: A

18. When driving in rain and encountering pedestrians with umbrellas or wearing raincoats, what should be done by motor vehicle drivers in order to yield?

A. Drive at a normal speed

B. Sound the horn to alert when approaching the pedestrians

C. Speed up and bypass on the left

D. Reduce speed and sound the horn in advance

Answer: D

19. How to reduce speed or stop when driving on a road covered with snow and ice?

A. Take full advantage of driving brake

B. Take full advantage of the control power from engine

C. Take full advantage of parking brake

D. Take full advantage of speed retarder

Answer: B

20. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D