张家口摩托车科目四仿真考试

1. What is the meaning of this sign?

A. No long time honking

B. Honk discontinuously

C. Reduce speed and honk

D. No honking

Answer: D

2. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

3. When an erosive material catches fire, it should not be put out with water cannon.

Answer: Y

4. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: D

5. What is the meaning of this sign?

A. No passing for small vehicle

B. Passing for small vehicle only

C. Passing for motorized vehicle

D. No passing for small vehicle

Answer: C

6. The drivers, loaders and supercargoes responsible for dangerous chemicals transportation should all full understand the chemical characteristics, potential risks, features of the packaging containers and emergency measures for any unexpected accidents.

Answer: Y

7. Dangerous chemicals possess the characteristics of explosion, inflammation, poison, erosion and radiation.

Answer: Y

8. Which of the following method is correct to rescue an unconscious person?

A. Apply cardio-pulmonaryresuscitation immediately

B. Press the philtrum of the wounded person with force

C. Continuously slap the face of the wounded person

D. Check the breath of the wounded person before other emergency treatments

Answer: D

9. Which of the following is a bad habit when changing lanes?

A. Turning on the indicator in advance

B. Observing closely before changing a lane

C. Change lanes at will

D. Not obstructing the passing of other normally moving vehicles

Answer: C

10. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C

11. How should lamps be used by the motor vehicle driver who follows a vehicle on a road section at night where he street light condition is good?

A. Turn off the headlamp

B. Use high-beam

C. Turn off all lamps

D. Use low-beam

Answer: D

12. What should motor vehicle drivers do when approaching an oncoming vehicle on a frozen road?

A. Cut speed as approaching each other

B. Pass each other by speeding up properly

C. Pass each other slowly by cutting speed in advance

D. Pass each other along the central line to the best

Answer: C

13. What is the meaning of this sign?

A. No U turn at intersection

B. No changing lane from both sides

C. No left or right turn

D. No going straight

Answer: C

14. What is the meaning of this sign?

A. Muddy road

B. Low-lying road

C. Overflowing road

D. Ferry

Answer: C

15. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

16. When a wounded person is under the wheel or cargo, the wrong method is to pull the limbs of the wounded.

Answer: N

17. What is the meaning of this sign?

A. Watch for pedestrians

B. Crosswalk

C. Village or town

D. Primary school

Answer: C

18. What is the meaning of this sign?

A. Road narrows on both sides

B. Road narrows on the right side

C. Road narrows on the left side

D. Bridge narrows

Answer: A

19. How to ensure safe driving at night?

A. Drive at speed limit

B. Cut speed and drive carefully

C. Maintain the current speed

D. Drive above the speed limit

Answer: B

20. When driving on a long downhill road, which is the best way to control driving speed?

A. Coast in neutral gear

B. Depress the clutch and coast

C. Use the engine to brake

D. Depress the brake pedal continuously

Answer: C