阿克苏考摩托车科目四英文版

1. What is the meaning of this sign?

A. Stopping temporarily is allowed

B. Long stopping is allowed

C. No long stopping

D. No stopping

Answer: D

2. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

3. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

4. When a wounded person is under the wheel or cargo, the wrong method is to pull the limbs of the wounded.

Answer: N

5. When carrying the wounded persons in coma or in danger of suffocation, they should lie face up.

Answer: N

6. When there is no bondage for rescuing a wounded person, towels, handkerchiefs, bed sheets and stockings can be used for dressing.

Answer: Y

7. When the wounded person is suffering main artery bleeding, where should the rescue personnel press by thumb to stop the bleeding?

A. The artery near the heart

B. The artery lower to the wound

C. The artery further from the heart

D. The artery in the center of the wound

Answer: A

8. How to ensure motor vehicles have sufficient power when driving uphill?

A. Downshift before reducing speed

B. Downshift after reducing speed

C. Downshift when the speed is excessively low

D. Downshift to the fullest extent

Answer: A

9. What is the meaning of this sign?

A. Bump road

B. Low-lying road

C. High outburst road

D. Hump bridge

Answer: B

10. What is the meaning of this sign?

A. No passing for small vehicle

B. Passing for small vehicle only

C. Passing for motorized vehicle

D. No passing for small vehicle

Answer: C

11. What is the meaning of this sign?

A. Turn right

B. One-way road

C. Going straight only

D. Straight-going lane

Answer: A

12. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

13. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

14. What is the meaning of this sign?

A. No yielding

B. Yield while crossing each other

C. Reduce speed and yield

D. Stop to yield

Answer: C

15. What is the meaning of this sign?

A. Intersection

B. Ring intersection

C. T-shaped intersection

D. Y-shaped intersection

Answer: A

16. When approaching a vehicle on a narrow slope, which one of the following ways is correct?

A. The descending vehicle yields to the ascending

B. The vehicle which is further from the slope crest should yield

C. The ascending vehicle yields to the descending

D. If the descending vehicle has reached the midpoint while the ascending vehicle has not yet set out, the descending vehicle must yield.

Answer: A

17. How should lamps be used by the motor vehicle driver who follows a vehicle on a road section at night where he street light condition is good?

A. Turn off the headlamp

B. Use high-beam

C. Turn off all lamps

D. Use low-beam

Answer: D

18. What is the meaning of this sign?

A. Exit and entry for disabled people

B. Watch for disabled people

C. Rest area for disabled people

D. Special passage for disabled people

Answer: B

19. What should motor vehicle drivers do when approaching an oncoming vehicle on a frozen road?

A. Cut speed as approaching each other

B. Pass each other by speeding up properly

C. Pass each other slowly by cutting speed in advance

D. Pass each other along the central line to the best

Answer: C

20. When a motor vehicle encounters a burning phenomenon, it should leave the vehicle quickly so as not to cause injury or asphyxia to the respiratory tract.

Answer: Y