成都摩托车科目四仿真考试

1. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

2. The first-aid measure to rescue a poisoned person is to _______.

A. Take warming-up measures

B. Bring him to a place where air is fresh

C. Give him artificial respiration

D. Depress the heart over the chest

Answer: B

3. What is the meaning of this sign?

A. Stop by the left side of the road

B. Downhill section left

C. Left turn only

D. Run by the left side of the road

Answer: D

4. When driving on a long downhill road, which is the best way to control the speed?

A. Coast in neutral gear

B. Take a low gear

C. Depress the clutch

D. Pull up the handbrake

Answer: B

5. Which lamp should be turned on when motor vehicles pass through a road section at night where the street light condition is good?

A. Front and rear fog lamps

B. Low-beam

C. High-beam

D. Hazard lamp

Answer: B

6. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: C

7. Gun powder, explosives and detonating powder belong to which of the following dangerous chemicals?

A. Oxidizing materials

B. Inflammable solid materials

C. Explosives

D. Self-igniting articles

Answer: C

8. What is the meaning of this sign?

A. School area

B. Watch for children

C. Crosswalk

D. Watch for pedestrians

Answer: B

9. What is the meaning of this sign?

A. Bump road

B. Low-lying road

C. High outburst road

D. Hump bridge

Answer: B

10. When a gas tanker is leaking heavily, which of the following measures is wrong?

A. Cut off the power

B. Wear gas mask and protect gloves

C. Turn off the valve to stop leaking

D. Evacuate people to the leeward side

Answer: D

11. What is the most frequent problem for driving on a muddy road?

A. High resistance force

B. Sideways slide

C. The motor vehicle bumps

D. Steering failure

Answer: B

12. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C

13. What is the meaning of this sign?

A. No U turn at intersection

B. No changing lane from both sides

C. No left or right turn

D. No going straight

Answer: C

14. When encountering a vehicle in front ascending on a mountainous road covered with ice and snow, what should the motor vehicle driver do?

A. Ascend after the vehicle in front passes the slope

B. Overtake the vehicle in front swiftly and drive on

C. Overtake the vehicle in front with a slow speed and drive on

D. Follow the vehicle in front closely

Answer: A

15. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

16. The article that cannot be used to stop bleeding by dressing is _________.

A. Bondage

B. Sling

C. Tourniquet

D. Hemp rope

Answer: D

17. What is the meaning of this sign?

A. No going straight and no changing to left lane

B. No going straight and no left turn

C. Allowed to go straight and turn left

D. No going straight and no right turn

Answer: B

18. When rescuing a wounded person in an emergency, it is necessary to firstly stop the bleeding by compression before other methods are taken according to the conditions of bleeding.

Answer: Y

19. What is the meaning of this sign?

A. More vehicles section

B. Passing slowly

C. Jammed section

D. Construction section

Answer: B

20. What needs attention when a motor vehicle drives on a road covered with ice and snow?

A. Braking length is extended

B. Anti-skating resistance will be greater

C. The adhesive force of the road will be greater

D. The braking length will be shorter

Answer: A