北海摩托车科目四仿真考试

1. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: D

2. When a motor vehicle temporarily stops in fog, which lamp should be turned on?

A. Hazard lamp, clearance lamp and rear position lamp

B. Left-turn indicator, clearance lamp and rear position amp

C. Headlamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: A

3. What is the meaning of this sign?

A. Bypass from left side

B. Continuous curves

C. Sharp left curve

D. Sharp right curve

Answer: C

4. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

5. What is the meaning of this sign?

A. Downhill section on right side

B. Driving by the right side of the road

C. Stopping by the right side of the road

D. Right turn only

Answer: B

6. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: C

7. When the wounded person is suffering main artery bleeding, where should the rescue personnel press by thumb to stop the bleeding?

A. The artery near the heart

B. The artery lower to the wound

C. The artery further from the heart

D. The artery in the center of the wound

Answer: A

8. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

9. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C

10. How to ensure safe driving at night?

A. Drive at speed limit

B. Cut speed and drive carefully

C. Maintain the current speed

D. Drive above the speed limit

Answer: B

11. What is the meaning of this sign?

A. Stop to yield

B. No stopping temporarily

C. No entry

D. No long stopping

Answer: A

12. When rescuing a person sustaining full-body burns the rescue personnel may spray cool water to his body to put out the fire.

Answer: N

13. When encountering a vehicle in front ascending on a mountainous road covered with ice and snow, what should the motor vehicle driver do?

A. Ascend after the vehicle in front passes the slope

B. Overtake the vehicle in front swiftly and drive on

C. Overtake the vehicle in front with a slow speed and drive on

D. Follow the vehicle in front closely

Answer: A

14. Which one of the following measures is correct when a motor vehicle intends to overtake but the vehicle infront refuses to yield?

A. Use a long-sounding horn

B. Follow the vehicle in front while turning high-beam

C. Wait for it to yield while keeping a safe distance

D. Use high-beam and low-beam alternatively

Answer: C

15. When putting out a fire disaster that gives out erosive steam or poisonous gas, the firefighters should wear gas masks and other related protective articles and should operate from the windward side.

Answer: Y

16. In emergencies, people¡¯s life safety should always be put in the first place.

Answer: Y

17. What is the meaning of this sign?

A. The lane for non-motorized vehicles

B. Yield non-motorized vehicles

C. No passing for non-motorized vehicles

D. Watch for non-motorized vehicles

Answer: D

18. What is the meaning of this sign?

A. Continuous down slopes

B. Steep downhill road

C. Steep uphill road

D. Continuous up slopes

Answer: A

19. When rescuing the injured, it is necessary to ________.

A. Save life first and treat the wounds later

B. Treat the wounds first and safe life later

C. Help the slightly wounded persons first

D. Help the seriously wounded persons later

Answer: A

20. When rescuing a wounded person who has been poisoned by toxic gas, the first measure is to send him to a place where air is fresh so that he will not continue to be poisoned.

Answer: Y