益阳考摩托车科目四英文版试题

1. When approaching another vehicle at night, why should the driver alternate between high-and-low-beam at a distance more than 150 meters?

A. Warn each other before passing

B. Driving habit

C. Easy to observe the situation ahead from either side

D. Courtesy

Answer: C

2. What should be checked before driving?

A. No parts need to be checked

B. Whether the tires have been cleaned

C. Where the spare tire is placed

D. The fastening and air pressure of tires

Answer: D

3. In emergencies, people¡¯s life safety should always be put in the first place.

Answer: Y

4. When a gas tanker is leaking heavily, which of the following measures is wrong?

A. Cut off the power

B. Wear gas mask and protect gloves

C. Turn off the valve to stop leaking

D. Evacuate people to the leeward side

Answer: D

5. What is the meaning of this sign?

A. Muddy road

B. Low-lying road

C. Overflowing road

D. Ferry

Answer: C

6. Which one of the following measures is correct when a motor vehicle intends to overtake but the vehicle infront refuses to yield?

A. Use a long-sounding horn

B. Follow the vehicle in front while turning high-beam

C. Wait for it to yield while keeping a safe distance

D. Use high-beam and low-beam alternatively

Answer: C

7. What is the meaning of this sign?

A. Customs inspection

B. Stop-for-inspection

C. Frontier inspection

D. No passing

Answer: B

8. Matches, sulfur and red phosphorus are _________.

A. Explosives

B. Inflammable solid materials

C. Self-igniting articles

D. Oxidizing materials

Answer: B

9. How should a motor vehicle follow the other vehicle In front when driving on a road covered with ice and snow?

A. Keep a long safe distance

B. Turn on hazard lamp

C. Change between high-and-low beam alternatively

D. Sound the horn in due time to give a notice to the vehicle in front

Answer: A

10. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: D

11. What is the meaning of this sign?

A. Bump road

B. Low-lying road

C. High outburst road

D. Hump bridge

Answer: B

12. When approaching a vehicle on a narrow slope, which one of the following ways is correct?

A. The descending vehicle yields to the ascending

B. The vehicle which is further from the slope crest should yield

C. The ascending vehicle yields to the descending

D. If the descending vehicle has reached the midpoint while the ascending vehicle has not yet set out, the descending vehicle must yield.

Answer: A

13. What is the meaning of this sign?

A. Reduce speed and go slowly

B. Watch for danger

C. Jammed section

D. Accident-prone section

Answer: B

14. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

15. When driving on a long downhill road, which is the best way to control the speed?

A. Coast in neutral gear

B. Take a low gear

C. Depress the clutch

D. Pull up the handbrake

Answer: B

16. What is the meaning of this sign?

A. Continuous down slopes

B. Steep downhill road

C. Steep uphill road

D. Continuous up slopes

Answer: A

17. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

18. How to ensure motor vehicles have sufficient power when driving uphill?

A. Downshift before reducing speed

B. Downshift after reducing speed

C. Downshift when the speed is excessively low

D. Downshift to the fullest extent

Answer: A

19. When driving on road sections where safe sight distance is affected, such as the top of a ramp, what should drivers do to ensure safety?

A. Rush through

B. Use hazard lamp

C. Cut speed and sound the horn

D. Drive at will

Answer: C

20. When using splints, sticks or tree branches to keep the unexposed bones in position, it is necessary that these things should exceed the upper and lower joints of the wound.

Answer: Y