泰安摩托车科目四英文版

1. What is the meaning of this sign?

A. Steep downhill road

B. Continuous up slopes

C. Steep uphill road

D. Embankment road

Answer: C

2. What is the meaning of this sign?

A. Bump road

B. Low-lying road

C. High outburst road

D. Hump bridge

Answer: B

3. When putting out a fire disaster that gives out erosive steam or poisonous gas, the firefighters should wear gas masks and other related protective articles and should operate from the windward side.

Answer: Y

4. What is the meaning of this sign?

A. No changing lane

B. No left turn

C. No going straight

D. No U turn

Answer: D

5. How to ensure motor vehicles have sufficient power when driving uphill?

A. Downshift before reducing speed

B. Downshift after reducing speed

C. Downshift when the speed is excessively low

D. Downshift to the fullest extent

Answer: A

6. When rescuing a person sustaining full-body burns the rescue personnel may spray cool water to his body to put out the fire.

Answer: N

7. What is the meaning of this sign?

A. No going straight and no changing to left lane

B. No going straight and no left turn

C. Allowed to go straight and change to left lane

D. No going straight and no right turn

Answer: D

8. What is the meaning of this sign?

A. No passing

B. Driving at reduced speed

C. Time limit for entering

D. No entering

Answer: A

9. What is the meaning of this sign?

A. U turn

B. Reversing

C. Left turn

D. Bypassing

Answer: A

10. Dangerous chemicals possess the characteristics of explosion, inflammation, poison, erosion and radiation.

Answer: Y

11. When a motor vehicle encounters an accident, the driver should pay attention to whether there is fuel leakage, pipeline rupture, so as avoid accidents.

Answer: Y

12. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C

13. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

14. When a motor vehicle stops in snow, which lamp should be turned on?

A. Front and rear fog lamps, clearance lamp and rear position lamp

B. Reverse lamp, clearance lamp and rear position lamp

C. Headlamp, clearance lamp and rear position lamp

D. Hazard lamps, clearance lamp and rear position lamp

Answer: D

15. What is the meaning of this sign?

A. Stop by the left side of the road

B. Downhill section left

C. Left turn only

D. Run by the left side of the road

Answer: D

16. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

17. When driving in thick or extremely thick fog, what should the driver do due to the low visibility in such weather?

A. Turn on the headlamp and drive slowly

B. Turn on the fog lamp and drive slowl

C. Park in a safe place

D. Drive slowly close to the roadside

Answer: C

18. When rescuing a wounded person in an emergency, it is necessary to firstly stop the bleeding by compression before other methods are taken according to the conditions of bleeding.

Answer: Y

19. Which of the following is a bad habit when changing lanes?

A. Turning on the indicator in advance

B. Observing closely before changing a lane

C. Change lanes at will

D. Not obstructing the passing of other normally moving vehicles

Answer: C

20. When encountering a vehicle in front ascending on a mountainous road covered with ice and snow, what should the motor vehicle driver do?

A. Ascend after the vehicle in front passes the slope

B. Overtake the vehicle in front swiftly and drive on

C. Overtake the vehicle in front with a slow speed and drive on

D. Follow the vehicle in front closely

Answer: A