玉树摩托车科目四英文题和答案

1. What is the meaning of this sign?

A. Downhill section on right side

B. Driving by the right side of the road

C. Stopping by the right side of the road

D. Right turn only

Answer: B

2. Which lamp should be used when motor vehicles pass hrough an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

3. What is the meaning of this sign?

A. Bypass from left side

B. Continuous curves

C. Sharp left curve

D. Sharp right curve

Answer: C

4. Which lamp should be turned on when motor vehicles pass through a road section at night where the street light condition is good?

A. Front and rear fog lamps

B. Low-beam

C. High-beam

D. Hazard lamp

Answer: B

5. What is the meaning of this sign?

A. No U turn at intersection

B. No changing lane from both sides

C. No left or right turn

D. No going straight

Answer: C

6. Which of the following is a bad habit when changing lanes?

A. Turning on the indicator in advance

B. Observing closely before changing a lane

C. Change lanes at will

D. Not obstructing the passing of other normally moving vehicles

Answer: C

7. When an erosive material catches fire, it should not be put out with water cannon.

Answer: Y

8. What is the meaning of this sign?

A. No passing

B. Driving at reduced speed

C. Time limit for entering

D. No entering

Answer: A

9. When a motor vehicle stops in snow, which lamp should be turned on?

A. Front and rear fog lamps, clearance lamp and rear position lamp

B. Reverse lamp, clearance lamp and rear position lamp

C. Headlamp, clearance lamp and rear position lamp

D. Hazard lamps, clearance lamp and rear position lamp

Answer: D

10. When a wounded person is unable to get off the vehicle by himself, he should be removed from the vehicle so as to avoid a secondary injury.

Answer: Y

11. What is the most frequent problem for driving on a muddy road?

A. High resistance force

B. Sideways slide

C. The motor vehicle bumps

D. Steering failure

Answer: B

12. What is the meaning of this sign?

A. No entering the intersection

B. No right turn

C. No changing lane

D. No U turn

Answer: B

13. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

14. What is the meaning of this sign?

A. No entry for bicycles

B. Lane for non-motorized vehicles

C. Special lane for bicycles

D. Bicycle stopping area

Answer: B

15. When rescuers enter the scene to rescue the wounded after harmful gas leakage caused by traffic accidents, they must wear air respirators or cover their mouth and nose with wet towels.

Answer: Y

16. What is the meaning of this sign?

A. Continuous down slopes

B. Steep downhill road

C. Steep uphill road

D. Continuous up slopes

Answer: A

17. When rescuing a person sustaining full-body burns the rescue personnel may spray cool water to his body to put out the fire.

Answer: N

18. The drivers, loaders and supercargoes responsible for dangerous chemicals transportation should all full understand the chemical characteristics, potential risks, features of the packaging containers and emergency measures for any unexpected accidents.

Answer: Y

19. When a motor vehicle temporarily stops in fog, which lamp should be turned on?

A. Hazard lamp, clearance lamp and rear position lamp

B. Left-turn indicator, clearance lamp and rear position amp

C. Headlamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: A

20. How to ensure safe driving at night?

A. Drive at speed limit

B. Cut speed and drive carefully

C. Maintain the current speed

D. Drive above the speed limit

Answer: B