河北摩托车科目四英文版

1. When the tire pressure is too low, what can happen when driving at a high speed?

A. Tire pressure will be unstable

B. Tire pressure will increase

C. Driving resistance will decrease

D. The tire will burst

Answer: D

2. When driving on a long downhill road, which is the best way to control the speed?

A. Coast in neutral gear

B. Take a low gear

C. Depress the clutch

D. Pull up the handbrake

Answer: B

3. When approaching a vehicle on a narrow slope, which one of the following ways is correct?

A. The descending vehicle yields to the ascending

B. The vehicle which is further from the slope crest should yield

C. The ascending vehicle yields to the descending

D. If the descending vehicle has reached the midpoint while the ascending vehicle has not yet set out, the descending vehicle must yield.

Answer: A

4. What is the meaning of this sign?

A. A manned level crossing

B. Multi-crossing of railway and road

C. Grade separation level crossing

D. An unmanned level crossing

Answer: A

5. Once inflammable gas causes a fire disaster, it should be put out with water in good time.

Answer: N

6. What is the meaning of this sign?

A. Bump road

B. Low-lying road

C. High outburst road

D. Hump bridge

Answer: B

7. What is the meaning of this sign?

A. Road narrows on the left side

B. Narrow bridge

C. Narrow road

D. Road narrows on the right side

Answer: B

8. What kind of harmful effect will be brought about by continuously using the foot brake on a long downhill road?

A. Shorten the engine¡¯s service life

B. Make the driver feel tired

C. Easily cause the vehicle to overturn

D. Reduce the braking efficiency

Answer: D

9. When a wounded person suffering bone fracture in the thigh, shank and spine, it is necessary to keep the fracture in position and refrain to move the wounded person.

Answer: Y

10. What is the meaning of this sign?

A. No long time honking

B. Honk discontinuously

C. Reduce speed and honk

D. No honking

Answer: D

11. When a motor vehicle stops in snow, which lamp should be turned on?

A. Front and rear fog lamps, clearance lamp and rear position lamp

B. Reverse lamp, clearance lamp and rear position lamp

C. Headlamp, clearance lamp and rear position lamp

D. Hazard lamps, clearance lamp and rear position lamp

Answer: D

12. Matches, sulfur and red phosphorus are _________.

A. Explosives

B. Inflammable solid materials

C. Self-igniting articles

D. Oxidizing materials

Answer: B

13. Which of the following measures is incorrect when a motor vehicle stops?

A. Stop at a stipulated place

B. Avoid stopping on pedestrian streets

C. Avoid obstructing the passing of other motor vehicles and pedestrians when temporarily stops on the road

D. Stop on the non-motor vehicle lane

Answer: D

14. How will the adhesive force of road change when speed increases on a damp and slippery road?

A. Increase sharply

B. Increase gradually

C. Decrease sharply

D. No change

Answer: C

15. When a wounded person is under the wheel or cargo, the wrong method is to pull the limbs of the wounded.

Answer: N

16. What is the meaning of this sign?

A. Crosswalk lights

B. Watch for pedestrians

C. Attention to traffic lights

D. Intersection

Answer: C

17. What is the meaning of this sign?

A. No passing

B. Driving at reduced speed

C. Time limit for entering

D. No entering

Answer: A

18. When a motor vehicle passes over an overflowing bridge, what should the driver do after stopping and observing closely?

A. Change to a high gear and pass rapidly

B. Constantly observe the changes of the flow

C. Prepare to stop at any time

D. Change to a low gear and pass through at a constant speed

Answer: D

19. What is the meaning of this sign?

A. No changing lane

B. No left turn

C. No going straight

D. No U turn

Answer: D

20. What is the meaning of this sign?

A. Reducing speed 40m ahead

B. Minimum speed is 40km/hr

C. Axle weight limit is 40 tons

D. Maximum speed limit is 40km/hr

Answer: D